Its been like this for a couple of years. But once the central locking has locked the door, it the won't re-open. You know the problem, the lock won't open off the key fob so you think it'll be worth changing it so that you don't have to use the key to get in the drivers door every time. It's held on by the usual plastic trim fasteners, most of which broke. There is no way of doing the job without, I tried, and tried, but it wasn't happening. These instances don't only make your drive uncomfortable but unsafe as well.
Not just a steel version of the original piece of junk. Making turns, driving at night and during bad weather conditions make vehicle lighting an essential, hence, caring for the ones installed in your Discovery is a necessity. This would be a major problem if I had a cargo barrier and couldn't get into the rear. Better design and correct material. Thanks Dennis There is a fix but it didn't work long for me. Specializing in four-wheel drives, Land Rover introduced the captivating Land Rover Discovery, a fusion of the Land Rover Defender and the Range Rover. Aside from that, it is also exposed to acidic elements that eat away the paint.
Then the key lock in the door just spins around like it isn't attached to anything: its not. You see the button move a little but thats it. The poor quality springs within your door lock mechanisms wear and can even snap causing these symptoms. So my advice is to get straight in and take it out from the start. These units run on an inline five-cylinder engine that could still provide the same off-road capability as the Defender. Furthermore, keep these lights clean since dirt sticking to them will result to poor illumination.
As long as the level of coolant is right, you can be sure that your cooling system will be safe from corrosion as well as foaming and electrolysis. No cancellation allowed once order is placed. There might be times when you might find it difficult to control your vehicle while driving, which can lead to accidents. Once you get the cover off, there are 4 screws around the lower pocket. You can use the motor from the super lock for the locking one by just swapping the motors. I am not going to risk messing things up for £45 by trying to do it myself. I can as I have larger stronger hands.
Worn shock absorbers can have a huge impact on your Discovery's overall road performance. I shall make sure I have one for next time. Such a pain sometimes not getting in through that door with the pick up from school. I undid the screw from the back of the inside-door-handle surround, and prized-off the interior door panel. There are two electric motors in the actuator.
Col What ever you do dont put of mending it and keep opening it from over the seat, I did that and eventually the lock actuator unit jammed up and wouldnt unlock, I then had to dismantle the door card etc with the door shut and then poke the unit with screw drivers etc to unlock it really not easy I didnt look at the part number you posted on here but my new unit was £70 so sounds right Thanks all for your advice. Remove the two large screws on the edge of the door and the 10mm bolt on the face, on this bolt there is a spacer between the lock mechanism and the door skin, take care to retain this. The first one to take out is the screw on the interior door handle cover. I should have had some to hand this time really. First thing to try is relocating the interior handle cable.
Thanks in advance Mike Rob answered 8 years ago There are 5 phillips head screws and several interior what I call plastic push pins. Hi all, thought I'd post a little report for those of you who haven't done the door lock mechanism on a D2 yet. You can't open the door once you have shut it. At present the passenger door is doing it. All other parts of the central locking are working as normal. It's a pain because I have to reach across and pull the door handle if a passenger wants to get in.
And the important word here is stock. You've come to the right place to get affordable quality Door Lock Clips for your Land Rover Discovery. Rear drivers door can be replaced by not genuine part but have to find one that fits. If any of them are dimming, you should be able to replace them immediately. Pulling the mechanism to bits every so often and cleaning it seems to be the only remedy.